 printable version
Camshaft position sensor
MODEL 1993-1997 years of release Check | PERFORMANCE ORDER | | 1. Make sure that between the terminal B + connector to connect a larger distributor of ignition and the negative battery terminal The battery voltage is present (see. Fig. Connectors connect the crankshaft position sensor / camshaft ). | | 2. Remove the ignition distributor into place and connect the larger of the two connection terminals. | | 3. Connect the voltmeter set to AC voltage measurement up to 5 volts, to terminals CID and GRD. Rotate the shaft of the distributor, make sure that one complete revolution of the voltmeter needle deviated once. Replace the sensor if it is faulty. |
|
Replacement In these models, the camshaft position sensor can not be replaced separately from the distributor of ignition. MODEL 1998 release Check Replacement Models with the 4-cylinder engine | PERFORMANCE ORDER |  | 1. Disconnect the connection of the sensor, turn off fixing bolts and remove the gauge. | | 2. Installation is spent upside-down removals. |
|
Models with the 6-cylinder engine | PERFORMANCE ORDER | | 1. Remove a gear belt and a pulley of a camshaft. | | 2. Disconnect the connection of the sensor, turn off fixing bolts and remove the gauge. | | 3. Installation is spent upside-down removals. |
|
|
