| 1. Drain the fuel system pressure. |
| 2. Disconnect the negative battery terminal. |
| 3. Drain the coolant from the engine and radiator. |
| 4. Drain the engine oil and remove the oil filter. |
| 5. Remove the air intake pipe. |
| 6. Remove the spark plug. |
| 7. Remove the intake manifold. |
| 8. Remove the exhaust manifold. |
| 9. Remove the cylinder head cover. |
| 10. Remove the timing belt cover and the belt. |
| 11. Remove the pump drive belts hydrostrengthening steering system and generator. |
| 12. Remove an arm of the generator. |
| 13. Remove the crankshaft sensor and the distributor of ignition or ignition coil. |
| 14. Remove the bolts securing the pump system hydrostrengthening steering pump and place to one side, without disconnecting from it hoses. |
 | 15. Disconnect hoses, remove the four screws and remove the coolant bypass tube. Disconnect all hoses and wires that prevent the removal of the cylinder head. |
| 16. Remove the camshafts and tappets. |
 | 17. Using the reverse sequence tightening, loosen several approaches (1/4 turn) the cylinder head bolts. |
| 18. Remove the cylinder head. |
| 19. Carefully clean the inner surface of the head (see. Subsection 3.2.10). |
The engine must be completely cool. 
