1. Open the hatch on 3/4. |
2. Unhook the spring clips on the front trim panel sun roof body. |
3. Fully open the hatch. |
4. Remove the top casing of the hatch. |
| 5. Remove the Phillips screws (arrows) and remove the guide bar. |
6. Close the door. |
| 7. Remove the left and right nuts (arrows). |
8. Remove the top hatch. |
9. Blow pressurized air weir top left and top right. |
10. Check the floating pads for damage and replace them if necessary. |
11. Clean the floating pads and lubricate anti-friction paste. |
12. Clean the guide rails, grease a working surface. |
| 13. Insert the dowel screws (arrow) on the left and right of the centering hole. |
14. Insert the top hatch. Fit the nuts without tightening them tight. |
| 15. With the illustration of special pre-mites hold hatch and then tighten the nut. |
16. Open the door. |
17. Screw the guide bar. |
18. Insert and secure the spring clamps trim hatch. |