 printable version
Accelerates and shift
Having got to the place, check the brake. Quickly warm up the engine. After reaching the desired temperature of the engine, check the steering. To avoid damage to the rear axle when starting off on a slippery road surface completely avoid the long scroll driving wheels.
Manual Transmission
Switching to the reverse gear is performed when the vehicle is stationary. To do this, lift the gear lever. Do not exceed the maximum permissible speed in the individual gears (see. Markings on the speedometer).
A warning  Leaving the car, put on 1 or reverse gear, put on the handbrake.
Automatic transmission
The individual gears are activated automatically, depending on: - Position of the lever;
- Speed of the vehicle;
- The accelerator pedal.
A warning
| Leaving a car or performing any work in the car with the engine running, set the hand brake and lever to position "P". |
Accelerates Set the lever to the desired position only in the idle motor cycling with the braking mode. Immediately release the brakes when setting off, otherwise there is a danger that the vehicle will begin to move prematurely. Installation of the accelerator pedal Few gas = = before triggering a slight acceleration. Many gas = = after triggering a strong acceleration. Too much gas (accelerator pedal is recessed below the full throttle) = switch back to a lower gear = maximum acceleration.
| 
