 printable version
Cruise control
Use it to hold any speed exceeding 40 km / h, including the switch. 1. Commit (touch switch). Acceleration (hold switch). 1. Commit (touch switch). Slow (hold switch). In normal mode, the vehicle is accelerated to a considerable speed with the accelerator pedal. Short touches to position 1 or 2, this rate will be maintained and the accelerator pedal can be omitted. If you want to increase the speed to overtake for example - use the accelerator pedal. If the pedal again let go again automatically set to the previously selected speed. If necessary the speed by increase or decrease slightly (for example, for the passage of traffic), hold the switch in position 1 or 2 to achieve the desired speed. If the switch is released again, the rate of new locks. Short touches the switch in position 1 or 2 speed will increase or decrease by 1 km / h. Switching off the cruise control switch briefly move into position 3. Cruise control is switched off when using the brake pedal or the speed is reduced to less than 40 km / h (eg in the mountains). Memory
If the switch at a speed greater than 40 km / h be set to 4, then again set the entered before shutting down the speed. If the ignition key to turn on 1 or O, the last recorded speed will be erased. Example: When driving downhill engine braking action is not enough, the speed will be introduced step over and, if necessary, will have to slow down. If the brake was not used, as soon as the slope is over, introduced earlier the rate is established again. The memory should be used when a clear confidence in the stored speed. In order not to exceed the engine speed, you can not install N for driving with cruise control.
| 
