printable version
Removing the outer door handles
| Fig. 11.31. After you have removed the seal (2) at the level of the door handles, open access to its retaining bolts (1) with the Allen
|
1. Remove the seal 2 (Fig. 11.31) the door out of the slot at the handle. 2. Turn the knob in the hole located under the screw 1 with the Allen SW 4. 3. Press the lock cylinder into the handle and remove the outside. 4. The door handle gasket remove downwards from the support. 5. In order to simplify the installation of reverse turn out completely outside the eccentric bolt Phillips from the bottom of the hole. 6. First, install the handle, and then install the lock cylinder. 7. Tighten the bolt with the Allen SW 4. 8. Eccentric bolt Phillips screw hole in the lower inside so that when opening the gap formed approximately 2 mm.
|