add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz W123
Home
 
Mercedes-Benz
W123
Introduction
Gasoline engines
Coupling
Manual transmission
Automatic Transmission
Driveline and rear axle
The front suspension
Rear suspension
Design and specifications
Removal, check and installation of shock absorbers
Removing and installing rear stabilizer bar
Removal and installation of the spring rear suspension
Removing and installing rear suspension assembly
The system automatically adjusting the position of the body
A steering
Brakes
Electrical
Body and Equipment
 


Hit Counter by Digits


print page printable version

Removal and installation of the spring rear suspension



PERFORMANCE ORDER

  1. Remove the rear suspension shock absorber or spring strut (on cars with the system controlling the position of the body).
  2. Fit the compression springs on the spring suspension. To do this, squeeze the spring to the full-trolley jack is matched under the trailing arm suspension, and then set the device for five turns of the spring.
  3. Lower the trailing arm suspension and high enough to relieve spring rear suspension with rubber pillow top support.
  4. Remove the rubber pad support and release the spring compressor, if necessary.
  5. Clean the upper and lower spring seat.
  6. Installation is the reverse order of removal. At the same time, take care that the lower end of the spring went into a groove trailing arm suspension. Tighten the nuts of shock absorber suspension after loading weight of the car.




« previos page
Removing and installing rear stabilizer bar
next page »
Removing and installing rear suspension assembly

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.