|
printable version
Removing and installing rear suspension assembly
| - Lift the rear of the car and put it on the support (pedestal). Wedges on the front wheels.
- Remove the exhaust pipe.
- Depending on the configuration, unscrew the screws and remove the heat shield from the bottom of the body, then remove the parking brake cables.
- Disconnect hoses from the hydraulic brakes brake calipers of the rear wheels and then install the cap.
- Remove the driveline.
- Remove spring rear suspension.
- Remove the nuts stabilizer bar to the connecting link and remove the links.
- Depending on the equipment, disconnect the wire sensor anti-lock brake system for the rear seat backrest and take them down.
- Substitute under the rear suspension (complete) a jack-cart.
- Remove the bolts from the front bracket to the bottom of the body.
- Remove located behind the rear axle bolts to a body suspension assemblies.
- Lower the rear suspension assembly, and bring her out of the car.
- Install in reverse order, tightening the nuts and bolts specified torque and replacing self-locking bolts rear assemblies. Bleed the brake system and adjust the parking brake.
|
|
|
|