 printable version
Safety precautions when working with airbag
The airbag sensor consists of a collision, the gas generator, the airbag control unit and of the cushions. The signal at the airbag inflation is generated by the control unit.
The car is equipped with airbag for driver and front passenger and side airbags, the airbag in the head and belt tensioners. The locations of airbags, as a rule, designated inscription ?�SRS Airbag?�.
It is not allowed to have on the front passenger seat child seat, oriented against the vehicle, excluding the special child safety seat in combination with an automatic child seat recognition.
 | For security reasons, is not allowed to carry out any work with parts belonging to the system, airbags and belt tensioner. |
Before removing and installing airbag unit driver:
| 1. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment. 2. Isolate the negative pole (-) of the battery to prevent accidental contact.
3. Set the wheels straight, and the steering wheel in the middle position.
4. Before removing the (touch) airbag unit, remove the electrostatic charge. To do this, briefly touch the door lock or the body.
5. When connecting the battery in the car should not be a people. |
|
General Precautions
Never install components airbags another car or other steering wheel. When replacing only install new parts.
Even after a minor accident, which did not lead to the triggering of the airbag, turn the airbag system and belt tensioner to check the service station Mercedes.
After triggering the airbag in the steering wheel, be sure to replace the steering wheel, at the side airbag, replace the lid facing the door, engaging the front passenger air bag, replace the instrument panel.
Airbag control unit must always be replaced after three positives.
The airbag may be checked only at the station. In no case can not be used to check the airbag warning lamp, voltmeter or ohmmeter.
Elements of the airbag, fell from a height of 0.5 m, it is imperative to replace.
It is to protect the elements of the airbag from the effects of heat or fire. Do not expose the elements of air bags to temperatures above + 100 ?� C.
Protect the airbag from contacting with water, oil or grease. After contact with water, grease or oil immediately wipe off the pillow.
After removing the airbags store it so that the soft side pointing up. When the reverse occurs storing up dangerous emissions from accidental ignition of the gas generator. Thus, there is a risk of injury.
If there is a break in the work, can not be left unattended airbag.
Do not disassemble airbag unit. If a fault occurs, he will be replaced in sets. Since the airbag contains an explosive substance, it is necessary to store it safely under supervision.
Before disposing of the vehicle components should be disposed of airbags. Disposal must be carried out by qualified companies.
When carrying out any work on the vehicle using a preliminary necessary to disunite Electric connector airbag control unit with the battery disconnected.
|
