REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Micra
		Introduction
		Controls and operation receptions
		Options and car routine maintenance
		Engine
		The engine cooling system, heating, ventilation and air conditioning
			Engine cooling system
			Heating, ventilation and air conditioning
				general information
				Adjusting the level of refrigerant
				Removal, installation, disassembly and reassembly of the control unit with a ventilation system with a heater and K /
				Removal, installation, assembly and disassembly of the unit K /
				Removing and installing heat exchanger
				Removing and installing electric fan heater
				Removal and installation of assemblage of the fan resistor and sensor system K / V
				Adjustment of cables of a drive damper
				Removal and installation of electric drive valves
				Removing and installing air ducts and vents
				Removing and installing refrigerant lines and compressor K / V
				Removal and installation of the other components of the system K / V
				Self-diagnosis of automatic K /
		The power supply system and exhaust
		Systems of an electric motor
		Manual box of a gear change and clutch
		Automatic Transmission
		Drive shafts, steering knuckles and Hub assembly
		Brakes
		Suspension and steering
		Body
		Onboard electric
		Diagrams

Removal and installation of assemblage of the fan resistor and sensor system K / V

PERFORMANCE ORDER

To access the resistor assembly, remove the glove box assembly (see chap. Body). Remove the two screws (?��31 on an illustration Building block K / V models with manual) and remove the resistor assembly (?��32).
To access the external temperature sensor (only models with automatic K / V), remove the grille (see chap. Body). Give a nut and remove the sensor (see. Illustration of the arrangement of the K / V).

To access the in-car sensor (only models with automatic K / V), remove the control unit ventilation system (see. Section Removal, installation, disassembly and reassembly of the control unit with a ventilation system with a heater and K / V). Remove the screw on the back of the unit and remove the gauge.

To remove the sun sensor (only models with automatic K / V) must be removed first edging sensor (see. Illustration of the arrangement of the K / V).
Installation is the reverse order.

Evaporator temperature sensor

PERFORMANCE ORDER

Discharge K / V in a specialized workshop.
Remove the K / B (see. Section Removal, installation, assembly and disassembly of the unit K / V).
Remove the pollen filter (see chap. Adjustment and car routine maintenance) and right air duct "at the feet" (see. Section Removal and installation of ducts and vents). On models with automatic K / remove additional e / motor shutter modes.

Remove the bottom casing of the heater fan and the cover of the expansion valve.

Slide down the evaporator and the fan shroud and remove the evaporator temperature sensor.

When removing and installing the sensor, do not rotate the insert thermistor.