printable version

Removal, installation, disassembly and reassembly of the control unit with a ventilation system with a heater and K /

Assembling the control unit without automatic models K /

1 - Switch heated rear window 2 - Switch K / 3 - Knob mode switch air distribution 4 - Fan speed control knob 5 - Knob temperature 6 - The tip of the actuator arm flap air	7 - Control 8 - Backlight 9 - Bowden cable shutter modes 10 - Cable door actuator air supply 11 - Bowden cable of air mixing flap

Assembling the control unit with automatic K /

1 - Outlining mode switch air distribution 2 - Edging display 3 - Edging temperature controller 4 - Cover the control unit 5 - Switch K / 6 - Switch for heated rear window 7 - Temperature controller	8 - Switch the automatic mode 9 - Switch the air distribution modes 10 - fan speed controller 11 - Switch mode of circulation 12 - Switch mode ventilation 13 - Control Unit

PERFORMANCE ORDER

Remove the trim center console (see chap. Body). On models without automatic K / remove the tip of the actuator arm damper air supply, remove the screws, release clamps and remove the control unit. On models with automatic K / remove the screws, release the clips and remove the controller. Go to step Fasteners and screw on models with automatic K / B are the same, where the models without him. Remove the cables drive dampers mixing air flow distribution mode and the air supply. Remove the screws and pull the unit from the center console. Disconnect the electrical wiring from the unit and remove it. If necessary, disassemble the control unit in accordance with the illustrated assembly control unit models without automatic A / C service and assembly of the control unit with automatic K / V. Installation is in the reverse order.