printable version

Removal, installation, assembly and disassembly of the unit K /

Fixing block K / V

Building block K / V models with manual control

* 1, 5, 11,13,23 - Screw * 2 - Line aspirator 3/15 - right / left fan cowl 4/14 - right / left casing 6/10 - Right / Left air duct "at the feet" 7 - cooling hose 8 - E / heater blower motor 9 - air mixing flap 12 - Catches 16 - Aspirator 17 - ventilation flap 18 - Stem blowing glass 19 - The flap blowing glass 20 - The damper air supply to the legs 21 - Radiator heater 22 - Cover the tube radiator 24 - Evaporator temperature sensor 25 - Laying pipe radiator 26 - The lower fan shroud 27.29 *, 31,33,35 * - Screw 28 - Bracket 30 - E / motor * (Rod **) flap air 32 - resistor assembly 34 - connector housing

36 * - E / motor valve 9 37 - valve stem 9 38 - Lever flap 9 39 - Spring 40,42,57,60 * 65 - Screw 41 - Lock tube heater 43 - Bolts 44 - Expansion Valve 45 - Insulator 46 - Cabin Filter 47 - * Link (lever **) flap 49 48/50 - Left / right casing flap 49 49 - Damper air 51 - Evaporator 52 - Cover the expansion valve 53 - Lever ventilation / airflow 54 - Stem ventilation / airflow 55 - draft ventilation / airflow 56,58,66 - Disc 59 - Rod damper modes 61 - E / motor valve modes 62 - Lever flap 20 63 - draft shutter 20 64 - Home flap

PERFORMANCE ORDER

Under the conditions of a specialized workshop discharge system K / V. Drain the engine cooling system (see. Section Replacement of a cooling liquid). Disconnect the hose from the evaporator low pressure and high pressure pipe. Plug the openings. Disconnect hoses from the radiator heater and plug the openings. When disconnecting the hoses can leak coolant. Remove the instrument panel (see chap. Body), clamps and wiring rack dashboard. Remove the screws and release the latches of the duct. Turn out bolts of fastening of the block K / V, bolts steering box and steering column. Release wiring clips (see. Illustration Fasteners block K / V). Remove the onboard control unit (BCM) - see chap. Onboard electric equipment. Remove the steering and then the block K / V. The components of the assembly block K / V presented the illustration Building block K / V models with manual control. Installation is in the reverse order. Replace all O-rings on the tubes. When installing the unit K / V, make sure that the drain hole so that it coincided with the drainage tube. Tighten fixture with demanded effort. Finally, tuck the cooling system and the K / B and make sure there are no leaks.