REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
			The petrol engine of 1.4 and 1.6 liters
				Kinds of repair without dismantling the engine from the vehicle
				Dismantle and engine major repairs
					Technical data
					Engine Overhaul
					Diagnostics of the engine with the help of the gauge
					The power unit with manual transmission
					The power unit with automatic transmission
					Cylinder Head
					Cylinder Head and Valves
					The pistons and connecting rods
					Crankshaft
						Removing the crankshaft
						Checking crankshaft
						Installation and check of backlashes in radical bearings
					Cylinder block
					The connecting rod-piston group
					Main and connecting rod bearings
					Piston rings
					Start the engine after major repairs
			The petrol engine of 2.0 liters
			Diesel engine
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
		Body
		Electrical

Removing the crankshaft

PERFORMANCE ORDER

1. Remove the oil pan, the chain (or chains) and a flywheel.
2. Remove the connecting rods with pistons.
A warning If pistons and connecting rods are no repair work will not be performed, then remove the cylinder head and connecting rod and piston group is not necessary. Pistons should be a push towards the combustion chambers.
3. Check the axial play of the crankshaft (see. Subsection 3.1.2.9.2), and then follow the steps below.
4. Remove the bolts and remove the holder of a back epiploon. With the weakening of the guide pins, remove them and store together with the holder.
	5. The main bearing caps are to be numbered from 1 to 5, since the front cover (arrows). If the numbers are not available, then apply white paint marks that match the serial number of the cover and determine its orientation.
	6. In the reverse order shown in the figure, remove the bolts main bearing caps, making 1/2 turn for the reception. Remove the bolts.
7. Remove the cover and remove the main bearing shells. Glue the ribbon each pad to the corresponding cover.
8. Carefully remove the crankshaft, and the displacement of the upper main bearing shells are not allowed.
9. Remove the cylinder from the upper root inserts. Glue the ribbon each pad to the corresponding cover. Remove persistent half rings of a third liner.

« previos page
Crankshaft