|
|
 printable version
AM-FM radio with electronic tuning
Receiver 1 knob audio
2. Click the button to configure the receiver and select TI-mode (Traffic information)
3. button NF automatic search RDS system over a range of webcasting
4. Display
5. Select button adjust the tone or balance | 6. The key tone control or balance
7. The station selection buttons
8. Side button to adjust the frequency increases
9. Click the button to tune in the station
10. Side button to adjust the frequency down
11. Power on the receiver and select AM or FM |
Cassette player 1 knob audio
2. Click the button to stop and remove the cassette,
3. Select button to play the cassette
4. Display
5. Select button adjust the tone or balance
| 6. The key tone control or balance
7. button Dolby NR
8. Side buttons for fast forward
9. Click the button to rewind the tape in both directions
10. Side buttons for rewind
11. Power on the player |
| PERFORMANCE ORDER | | 1. Turn on the receiver by pressing the LMU, select stereo or mono reception, or click on TI's station receiving broadcast traffic information (see. Subsection 1.5.4). The display shows the symbols L, M or U. The receiver can also be turned on by pressing the knob ?�PWR.VOL?�. | | 2. Adjust the volume by turning the knob ?�PWR.VOL?�. | | 3. Tune to the desired station (see. Subsection 1.5.2, subsection 1.5.3). | | 4. When tuned to the FM station receiver automatically switches to stereoreception. The display shows the symbol ST. If the signal is weak, it will automatically narrowing reception band to reduce noise. If the signal is very weak, it will automatically switch the receiver to the mono reception mode. | | 5. Set the tone and balance (see. Subsection 1.5.5, subsection 1.5.6). | | 6. To turn off the receiver, press the knob ?�PWR.VOL?�. |
|
|
|
