|
printable version
The fan
All injection engines the fan is switched from the processor control unit, under the influence of a temperature sensor, which is screwed into the intake manifold (cover side chains). On cars with petrol engines the fan is activated when triggered thermoswitch, which is screwed into the cover of the thermostat. For vehicles with air conditioning and (or) the automatic transmission includes two fan.
Independently allowed only a simple check. Check
PERFORMANCE ORDER | 1. Warm up the engine and set to idle. | 2. The fan should turn on after a little more than 2 minutes (the temperature gauge must be on the edge of the red sector). | 3. Otherwise, stop the engine and disconnect the fan connector. | 4. If the fan does not turn on when connected directly to the output of 12V connector is faulty motor. | 5. If the fan is turned on when the line voltage is applied, the faulty wiring, or thermoswitch control unit (see control procedures. In section 4.6.1). | 6. The remaining checks are performed in the service of car-care center. |
|
Withdrawal
PERFORMANCE ORDER | 1. Disconnect the battery from weight. | | 2. Disconnect from the electric socket. | | 3. Remove the screws, lift and remove the fan assembly to the housing. |
|
Setting
Installation is performed in reverse order.
|
|