 printable version
Removing and installing the lamp
| Fig. 331. Details of lights: 1 - lamp; 2 - parking light bulb; 3 - the parking light bulb holder; 4 - a cover; 5 - Safety spring clip; 6 - a lamp with a double filament; 7 - actuator adjustment range of lighting
|
Fig. 331 shows a device lights. To remove and install the lamp need to do the following: - From the engine compartment to remove the protective cover;
| Fig. 332. Type compounds on the inside of the headlamp 1 - electric connector; 2 - safety clip; 3 - safety tabs; 4 - parking light bulb; 5 - lamp lights
|
- Disconnect the electrical connector from the bulb socket with 5 lights (Fig. 332); - Raise the safety clip 2 on both tabs 3 and remove the bulb from the lamp insert. Do not take the new lamp with your fingers. Insert the lamp so that the lamp socket tabs went into the grooves of the reflector. After replacing the lamp lights always check the headlight adjustment and adjust if necessary. Better check the adjustment range in the service station.
| 
