add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Sharan (from 1995 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Sharan
Home
 
Volkswagen
Sharan
Introduction
VR6 engine
The two-liter engine (ADY)
Engine oil
Cooling
A fuel injection system VR6 engine
The system Simos injection 2.0-liter engine
The ignition system
Coupling
Manual 5-speed gearbox
The drive shafts
Power steering
Front suspension
Rear suspension
Brakes
Electrical
Accumulator battery
Generator
Starter
Checking starter
Removing and installing starter
Dismantling and assembling starter
Wipers
Headlights
Rear lights
Replacement lamps front indicators
Diesel engine
The lubrication system of the diesel engine
The cooling system of the diesel engine
The power supply system of the diesel engine and turbocharger
Map service.
Applications
Wiring
 


Hit Counter by Digits


print page printable version

Starter






The main part of the system start-up is a DC motor - the starter motor, powered by AB. The starter consists of an electric motor drive mechanism and the traction relay. Enabling contacts made him a starter magnetic switch that engages the starter pinion and flywheel and ensures the inclusion of the starter circuit when the switch contacts are closed. The drive mechanism transmits torque from the flywheel to a starter shaft via a gear train and after the start of the engine to prevent torque transmission from the flywheel to the starter shaft. Starter is the most powerful consumer of electricity in the car.


Possible faults, their causes and remedies
Cause of Failure
Remedy

When you turn on the ignition warning lamp discharge AB
1. Discharged AB.
1. Start the engine using the auxiliary starting wire by the "Booster" or towing.

2. Blown warning lamp.
2. Replace the bulb.

3. The wire is loose or oxidized AB corresponding terminals.
3. Tighten the mounting wires. Check connections, if necessary, clean the terminals and the terminals of the battery.

4. The electrical circuit is torn between the ignition switch, indicator lamp discharge batteries and generator.
4. Refer to the workshop.

5. Blown fuse in the mounting block.
5. Replace the fuse.

6. Defective carbon brushes or voltage regulator.
6. Replace the carbon brushes and the voltage regulator.

The warning lamp lights up when the engine
1. Slip the alternator drive belt
1. Adjust the belt tension.

2. Open or short circuit in the diode field supply.
2. Replace damaged diodes.

3. Faulty voltage regulator.
3. Replace the voltage regulator.

4. Open one or more valves of the generator.
4. Replace the rectifier unit.

5. Open or Winding short circuit in the stator winding, closing it to the "masses."
5. Replace the generator stator.

6. Short circuit on "weight" the winding of the generator.
6. Replace the rotor of the generator.

Increased noise generator
1. Loose nut securing alternator pulley.
1. Tighten the nut.

2. Bearing damaged generator.
2. Replace the bearings.

3. Winding short circuit or short circuit on "weight" of the stator winding.
3. Replace the stator.

4. A short circuit in one of the valves of the generator.
4. Replace the rectifier unit.

5. Scrape the brush.
5. Wipe the brushes and slip rings cotton cloth soaked in gasoline.





« previos page
Repair the generator
next page »
Checking starter

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.