printable version
Removing and installing lights
Removing the lights sequence is as follows: - Remove the turn signal near the headlamp (see. Sect. 16.7); - Remove the radiator grille: - Remove the four screws on the grille; - Squeeze the top of the radiator grille and lift it out of the bottom fastening. - In the engine compartment, remove the protective cover of the headlamp; - Disconnect the electrical connector located on the rear side lights; - Remove the four screws in the front mounting lights (two on top and two on the bottom) and remove the headlight assembly towards the front. The installation of lights spend in reverse order of removal. Pay attention to the fact that the outside lights to guide fits snugly against the edge of the wing. Tighten the screws that secure the headlamp to 8 Nm. After installing the lights, check and, if necessary, make adjustments headlights. We recommend adjusted on the SRT.
|