printable version
Safety precautions when working on the system power supply
When working in the electrical system to avoid injury or damage to the devices of the system, observe the following precautions: - Do not operate the generator disconnected AB. This will cause the emergence of short-term surge in the output of the generator, which could damage the voltage regulator and electronic devices in the vehicle electrical system; - Do not check working capacity of the generator on the "spark" even a brief connection of the generator output with "weight". Check the generator only with the help of ammeter and voltmeter; - Never to be confused with each other wires of the voltage regulator; - Never turn on the voltage regulator, if it is connected in any way with "mass", otherwise it will damage him immediately; - Never remove the generator if AB has been disconnected from the electrical system; - When installing AB note to "negative" wire is connected to "weight"; - Do not Megger test vehicle wiring or lamp, a supply voltage of 12 V. If such verification is necessary, preliminary disconnect wires from the generator; - If AB installed in the car and it is planned to recharge the charger, then disconnect from the findings of the two wires AB. Correctly connect the charger to the terminals AB; "Minus" AB must always be connected to "weight", and "plus" - connected to the generator terminals. Faulty reverse switch AB immediately cause damage to the rectifier and voltage regulator; - With electric welding units and parts of the car body must disconnect all cables from the generator terminals and AB.
|