 printable version
Removal of the electronic climate control system (ELP)
If you switch the system does not work, you must replace the entire panel. The procedure for withdrawal of electronic climate control (ELP): 1) Remove the front cover, gently lift it off the edge of a penknife and pulling out.
| Fig. 10.79. Removing the front panel
|
2) Remove the screws (4 torx); 3) remove the base of the console (press gently on the edge of a screwdriver);
NOTE To remove the base of the console, first pull out the tape recorder forward a few centimeters. |
| Fig. 10.80. Screw in the bottom of the console
|
4) Remove the screw behind the base of the console (Fig. 10.80) and slightly pull forward the console; 5) disconnect switches and connectors from the radio and remove the console. 6) Tilt the control panel (block) downwards and disconnect the connector and hose; 7) remove the block. Installation is the reverse order.
| 
