add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Accent
Home
 
Hyundai
Accent
Instructions
Engine
Engines SOHC
Technical data
Toothed belt
Check toothed belt tension
Adjusting the tension of the toothed belt
Ribbed Belts
Engine Supports
The front cover and the oil pump
Air filter (ACL)
Cylinder head
Rocker
Hydraulic jacks of backlashes of valves
Replacing the valve seat
Replacing the valve guide
Valve
Camshaft
Cranks
Crankshaft
Flywheel
The piston pin
An exhaust manifold
Intake manifold and the air chamber
Cylinder block
Removing and installing engine and gearbox
Exhaust
Troubleshooting
Engines DOHC
Greasing system
Cooling
Control, reduced toxicity
Fuel system
Ignition system
Coupling
Transmission
Axes and power shafts
Suspension
Steering
Brakes
Body
Air
Electrical equipment
Appendix
Wiring
 


Hit Counter by Digits


print page printable version

Engines SOHC



If the engine works badly or with faults, check up system of ignition and fuel system.
If the reasons for the poor performance of the engine could not be found, inspect a compression. Regular carrying out of this check will allow you to advance and prevent the occurrence of faults.

PERFORMANCE ORDER
1. Check the engine oil level. Make sure the starter works normally, but the battery is fully charged.
2. Start the engine and warm it to a temperature of 80-95 ?� C.
3. Turn off the engine and remove the spark plug caps from the high-voltage wires.
4. Remove the spark plugs.
5. Turn the crankshaft of the engine.
6. Screw the tip compressometer in the spark plug hole.
7. Fully open the throttle.
8. the Starter cranked shaft of the engine about 4 turns on the scale and determine the compression device.

Compression: 1.62 MPa
The minimum allowable compression of 1.52 MPa

9. Repeat steps 6-8 on the remaining cylinders.
10. If the compression is low in all the cylinders through the spark plug hole into the cylinders fill a few drops of engine oil and repeat steps 6-8.

1) If the oil filling compression raises perhaps worn piston rings.
2) If the compression is at the same level may be burned or damaged valves cylinder head gasket.
3) Replace the spark plug and connect them to the high-voltage wires.

The inhaling moment: 20,4-30,6 N ??? m





« previos page
Engine
next page »
Technical data

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.