add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Elantra
Home
 
Hyundai
Elantra
Gasoline engines 1.6, 1.8 and 2.0 liters
The diesel engine of 2.0 liters
Greasing system
Cooling
Fuel system
Control systems and emission control
Ignition system
The system of preliminary heating of the diesel engine
Coupling
Manual transmission
Automatic Transmission
Drive shafts, front and rear axles
Suspension
Steering
Brakes
Technical data
Check the brake servo
Check unilateral vacuum valve
Bleeding the hydraulic system of a drive of brakes
Adjust the parking brake stroke
Brake pedal
Vacuum brake booster
The main brake cylinder
Replacing the front brake pads
Caliper front brake
Rear disc brakes
Rear drum brakes
Replacing the working brake cylinder
Pressure regulator
Brake tubes and hoses
Parking brake
Anti-lock brakes (ABS)
Hydraulic block HECU
Wheel speed sensor
Bleeding the hydraulic system of a drive of brakes with scanner use
Troubleshooting
Body
The air conditioning system
Electrical equipment
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Bleeding the hydraulic system of a drive of brakes with scanner use



Any hydraulic system works normally if air is removed from it.

PERFORMANCE ORDER

  1. Remove the cap from the expansion tank with brake fluid.

When pumping pressure does not depress the brake pedal

Recommended brake fluid: DOT3 or DOT4.

  1. Remove the cover from the bleeder, and attach it to one end of the transparent hose and the other end of the hose, insert the glass container of sufficient volume, half-filled with brake fluid.
  1. Connect the scanner to the diagnostic connector located under the dashboard.
  1. In accordance with the instructions for operating the scanner, select the appropriate option.

Consider the maximum working time of ABS works with the scanner to prevent burnout of the motor pump.

1) Set the firm hyundai car manufacturer.

2) Set the name of the car.
3) Set the test anti-lock brake system
4) Establish a method for removing the air.

5) Click ?�YES1?�, to enable the pump to the motor and solenoid valve.

6) Wait for 60 seconds before the operation of removal of air, since, otherwise, can damage the motor.

  1. Slowly press the brake pedal several times. While pressing the brake pedal wrench to loosen the bleeder valve and wait until the brake fluid flows out without air bubbles. Tighten the bleeder valve and release the brake pedal.
  2. Repeat step 5 to remove the air from the brake mechanisms of other wheels.
  1. Tighten the bleeder valve. Tightening torque: 7-9 N ??? m.




« previos page
Wheel speed sensor
next page »
Troubleshooting

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.