printable version

Removal and installation of the main brake cylinder

This work also must be done by the amateur mechanic. Again, this is not due to the complexity of procedures of removal, installation, and due to the need for adequate pumping HCU. The manufacturer recommends a preliminary pumping of the master cylinder on the bench prior to installation on the vehicle.

After the installation is carried out, the master cylinder and the HCU ABS should be prokachany using the scanner DRB II (then the entire system must be bled even manually). The scanner is a very expensive device and can serve as a good investment for a workshop of dealer branch. If your car there are any problems associated with the failure of the combined control and drag it to a workshop of dealer branch or a specialized workshop.