REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sportage (1999 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sportage
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system, motor control / emission control and exhaust
		Systems of an electric motor
			Ignition gasoline engine
			System facilitate cold starting of the diesel engine
			Charge and start systems
		A five-speed manual gearbox gear
		Automatic Transmission
		Transmission Line
		Brakes
		Suspension and steering
		Body
		Onboard electric
		The control body dimensions
		Wiring

Systems of an electric motor

Specifications

Separate characteristics are resulted also in the text of the chapter and in the case of compulsion of their performance are highlighted in bold.

Ignition gasoline engine

Type	Electronic direct ignition (DIS) to the idle spark operates under the ECM, is guided by the crankshaft position sensor (CKP) and camshaft (CMP) shafts
Ignition timing	4 ?� + 2 ?� before TDC (ECM is running, is not subject to adjustment)
Ignition order	1-3-4-2
Ignition coils
Type	Two dual coil modules (one for two cylinders)
Power supply reel (considering ballast), B	12.0
Primary resistance, Ohm	0.45 ÷ 0.55
The secondary resistance, Ohm	13 ÷ 15
BB wires
Resistivity, ohm / m	16
Spark plug
Type
NGK	BKR6E-11
Bosch	FR7DCX
Champion	RC7YC4
Beru	14FR-7DUX
Autolite	APP3923
Electrode gap (all manufacturers) mm	eleven

System facilitate cold starting of the diesel engine

The duration of the phases of preheat and postnakala	See. Section System to facilitate cold starting of the diesel engine
Cutout glow plug relay	See. Section System to facilitate cold starting of the diesel engine
Resistance to glow plug relay (see. Section Checking glow plug relay), Ohm	13

Charge system

Accumulator battery
The density of the electrolyte at 25 ?� C (all types), kg / dm ³
Nominal value	1.280
Maximum difference allowed between banks	0.04
Nominal output voltage, V (grounding of the negative pole)	12
The capacitive characteristic (relative to 5 hours) Ah
Petrol models	60
Diesel models	68
Generator
Type (all models)	Alternating current
Output characteristics, BA
Petrol models	12.-70
Diesel models	12-60
Controller type (all models)	Transistor, built into the reel unit
Rated speed, rev / min
Petrol models	No data available
Diesel models	5000
Operating speed ^range, min -1
Petrol models	No data available
Diesel models	1000 ÷ 11000
Number of poles
Petrol models	No data available
Diesel models	12
Vacuum pump (diesel models)
Depth vacuum mmHg. Art.
When the generator speed of 1500 rev / min, after 20 seconds	Not less than 440
When the generator rotational speed 3000 rev / min, after 20 seconds	Not less than 580
The length of the blade slide, mm	13.0 ÷ 13.5
Inner shell diameter, mm	57.0 ÷ 57.1

Starting system

Drive type crankshaft
Petrol models
Models with Manual transmission	Gearless
Models AT	Geared
Diesel models	Gearless
Maximum current while cranking the engine, and
Petrol models	130 ÷ 158
Diesel models	No data available
Starter
Output power, kW
Petrol models
Models with Manual transmission	0.9
Models AT	12
Diesel models	20
The length of the brush, mm
Nominal value
Petrol models	17
Diesel models	18
The limit value
Petrol models	11.5
Diesel models	eleven
Developing brush spring force (all models), H	8.8

The amount of beating anchor assembly (all models)
Nominal value	0.05
The limit value	0.4
Grooving collector (all models)
The minimum allowable diameter, mm	31

Working backlash gears (petrol models), mm	0.5
Axial backlash gear (diesel models)

Working backlash gear starter (petrol models)


1 - shaft gears 2 - Axial clearance 3 - Retaining Ring 4 - Disc	5 - Bracket washer 6 - Shim 7 - Reduction gear

Efforts of a tightening of carving connections, Nanometer

Efforts of a tightening of certain fastener elements can be shown directly in the section where they are highlighted in bold.

Petrol models

Bolts coil assemblies	19 ÷ 25
Spark plug	25 ÷ 30
Bolts starter and the support bracket	37 ÷ 54
Nut terminals in starter	16 ÷ 23
Bolts of fastening of the inlet pipeline	37 ÷ 54
Axial securing bolts and generator	38 ÷ 51
Screw the bearing housing of the generator	2.0 ÷ 5.4
Bolts of a cover of the generator	2.0 ÷ 5.4
Nut alternator drive pulley	59 ÷ 98
Tighten the screws on the rectifier diode assembly	2.0 ÷ 5.4
Bolt support tensioner	19 ÷ 26

Diesel models

Glow plugs	14.7 ÷ 19.6
Bolts starter and the support bracket	37 ÷ 54
Nut terminals in starter	16 ÷ 23
Bolts of fastening of the generator (see.
A	19 ÷ 26
AT	38 ÷ 51