|
printable version
Checking oil pressure
Gas engine | - Check the oil level.
- Warm up the engine, the oil temperature should be at least + 80 ?� C. This temperature is achieved in the normal ride 15 km.
- Injection engine: Unscrew the intake manifold mounting.
- Disconnect the cable from the oil pressure sensor and unscrew the sensor. Catch any escaping oil.
- Screw the pressure sensor instead of the appropriate gauge.
| - Start the engine, set to work with a test speed and take readings.
|
- Unscrew the pressure gauge.
- Cover 2-3 thread sealant oil pressure sensor, for example, Loctite 242, insert and secure the sensor with a force of 15 Nm.
| - Injection engines: Fit mounting intake manifold and tighten with a force of 25 Nm and 45 Nm.
|
|
|
Table oil pressure Engine | Oil pressure in bar | Verification number of revolutions | Gas engine | 2.0 - 3.0 3.0 - 4.0 | 1000 rev / min 3000 rev / min | Diesel engine | min. thirty | 3000 rev / min |
Diesel engine | | - Unscrew oil hose on the vacuum pump. Catch any escaping oil.
|
| - Screw the appropriate gauge to the splitter in the pipeline.
|
- Start the engine, leave work with a test speed and take readings.
- Remove the pressure gauge and screw the splitter and the oil hose to a vacuum pump.
- If the oil pressure does not correspond to the desired value. See
|
|
|
|