|
|
 printable version
Cylinder head cover
Withdrawal
| PERFORMANCE ORDER | | 1. Disconnect the negative battery terminal. | | 2. If you remove the back cover of the cylinder head, remove the inlet manifold. | | 3. Disconnect the wires from the spark plugs and unscrew candles. |  | 4. Remove the screws fixing the wires (A), remove the vent (B). Unscrew the screws (indicated by arrows). Disconnect the hose from the tube without removing the tube itself. | | 5. Remove the covers of the two heads of the two screws holding the cover for the timing belt. | | 6. Unscrew the bolts and remove the head cover. If the cap sits too tight, tapped on it with a wooden hammer. Not to hook the edge of the lid, otherwise you will damage them. |
|
Setting
| PERFORMANCE ORDER | | 1. Thoroughly clean and wipe solvent joined surfaces of the cover and the cylinder head. |  | 2. Apply sealant to the specified locations. |  | 3. Place the gasket into the groove on the head cover and replace the cover. | | 4. Tighten the nuts to the proper torque. | | 5. Establish the remained details, get the engine and check for leaks. |
|
|
|
