|
|
 printable version
Oil pump
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the oil pan. | | 2. Remove the gas distribution belt and crankshaft sprocket. |  | 3. Remove the 4 bolts (arrows) and remove maslozaborny pipe. | | 4. Remove the air conditioning compressor and slide it to the side, do not disconnect the hose from the compressor. |  | 5. Remove the compressor bracket. | | 6. Remove the pump system hydrostrengthening steering, remove the pump bracket and slide the pump aside, without disconnecting from it hoses. | | 7. Remove the bolts of the oil pump and remove the pump. |
|
Check
| PERFORMANCE ORDER | | 1. Remove the O-ring gasket and oil pump. | | 2. Twist the cap reducing valve, remove the spring and plunger. | | 3. Remove the screws and remove the oil pump. | | 4. Carefully clean and wipe acetone joined surfaces of the pump and the engine block. | | 5. Remove the internal and external gear pump. Rinse all the elements of the pump in a solvent. | | 6. Inspect the relief valve spring and measure their length. | | 7. If the springs are damaged or length is out of specification, replace the spring. | | 8. Install the gears in the pump housing and perform the necessary measurements (see. Subsection 3.2.14). |
|
Setting
| PERFORMANCE ORDER | | 1. Remove the oil seal of the crankshaft using a screwdriver. | | 2. Apply universal grease to the new packing and set it in place. | | 3. Install the gear pump casing. | | 4. Fill the pump cavity with petroleum jelly. Install the oil pump cover and tighten the cover screws, pre-lubricated them with sealant. | | 5. Grease the piston relief valve oil and install valve elements in the pump housing. | | 6. Apply sealant at the junction surface of the pump. | | 7. Replace the O-ring pump. | | 8. Place the pump, insert and tighten the screws. | | 9. Install the remaining parts. |
|
|
|
