REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 (from 1991 to 1998, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	626
		Instructions
		Maintenance
		Engines
			Petrol engines (1,6 and 1,8 liters)
			Gasoline 4-cylinder engine (2 liters)
			Gasoline engine V6 (2,5 liters)
			A partition of engines (1,6 and 1,8 liters)
			Bulkhead engine (2.0 liters and 2.5 V6)
				Introduction
				Specifications
				Repair work without dismantle of the engine from the vehicle
				Engine Overhaul
				Check with a vacuum gauge
				Compression Test
				Methods for removing the motor
				Removing and installing engine
				ENGINE OVERHAUL
				A partition and check of a head of cylinders
				Valves
				Assembling the cylinder head
				Removal of pistons and rods
				Removing the crankshaft
				Checking cylinder
				Honing cylinders
				Check of pistons and rods
				Checking crankshaft
				Check and selection of radical bearings and bearings of rods
				Check the camshaft and pushers
				The order of assembly of the engine
				Installation of the piston rings
				Installing the crankshaft
				Installing the crankshaft rear oil seal
				Installation of pistons and rods
			The diesel engine of 2.0 liters
			Systems of an electric motor
		Heating and ventilation
		Fuel system
		An exhaust system
		Transmissions
		Coupling and semiaxes
		The brake system
		Chassis
		Body
		Electrical
		Wiring
		Tips and Tricks

Honing cylinders

To perform this procedure requires special tools and skills, so the best solution would be, if you refer to specialists.

After honing on the cylinder walls must remain pattern of cross lines intersecting at an angle of approximately 60 ?�.