printable version
Replacement bulbs others
Highlighting in sunshields
| Fig. 10.20. Lamp assembly as defined in sunshields installed in the spring contacts (arrows)
|
Use a screwdriver to pry the lid (the opening at the bottom edge) (Fig. 10.20). Lighting glovebox
| Fig. 10.21. Replacing the lamp in the glove compartment
|
To replace the lamp assembly as defined unplug the lamp from the niche (Fig. 10.21). The lamp in the trunk
| Fig. 10.22. Replacing the lamp in the trunk
|
When you open the trunk, click on the lamp back, remove it from the niche and replace the lamp assembly as defined (Fig. 10.22). The lighting of the instrument cluster Lamps with glass plinth lighting and very small bulbs are installed in combination inside. Therefore, to replace them, you must first remove the instrument cluster. Lighting switch Backlight partially fixed and replaced with switches. In some switches, however, set the lamp with glass base and plug-in contacts. To replace them, first remove the switch from the instrument panel. Lighting control of the heating system Both rotary switch for the fan and air distribution, remove the cloth wrapped forceps. Outside, on the side of the axis switch is a small white cap. Slide it and replace it with a sharp instrument established under a lamp with a glass cap. Lighting light switch Remove the rotary switch. Below that is a lamp with a glass cap, which should light up when the rear fog lamp. Lighting ashtrays Remove the ashtray insert member. Under cigarette lighter side mounted lamp with a glass cap. Carefully replace it with a cloth instrument. The selector of an automatic transmission Remove the trim center console and a little lift. Ahead on the left side of the switching mechanism is insert the bulb holder with a glass cap.
PRACTICAL ADVICE Replacing bulbs If you have recently replaced the lamp is no longer illuminated, this does not always mean that it burns. As a rule, older machines corrosion often prevents the passage of current to the lamp cartridge. In this case, the lamp will light up if its move in the cartridge. In this case, clean the cartridge contacts and lamps. Check the contact with the lamp holder. Lighting probe is easy to check whether the voltage is applied to the cartridge. To do this, locate the lamp on the wiring diagram and check the chain. If before installing the lamp, you open hands touched the glass bulb, then be sure to wipe it with a clean cloth so that the remaining traces of moisture is then evaporated with a hot lamp, resulting in opacification of the lens. The board dash current to the lamps passes through flat copper connection paths. If originated scratch interrupts this track can be done in this place from a piece of jumper wire, solder it ends on both sides of the scratch. |
|