|
|
 printable version
Removing and installing the rear shock absorber
Shock absorber and spring suspension of rear wheels
 | 1 - locknut 30Nm
2 - Nut
3 - Disc
4 - Rubber buffer
5 - Rubber buffer | 6 - Shock
7 - Bolt
8 - Nut M10 55nm
9 - Cup spring |
Models without adjustment clearance
In case of repair shock absorbers, regardless of manufacturer, must be replaced each separately. However, the performance of the shock absorber must match the color applied to a label.
Withdrawal
| 1. Remove the trunk side trim and remove it, refer to Section Removal and installation of facing in the cargo hold.  | Shock absorbers at the same time serve as an elastic stop for the rear wheels. Therefore, the top support of the shock absorber should be disconnected only when the car standing on wheels, the axis does not fall down when you disconnect the damper. If the vehicle is raised, it is necessary to back spring arm garage jack.
When disconnecting the upper part of the suspension should not be allowed rotational damper rod. Otherwise, disconnect the cylinder may occur. Danger Emergencies! |
 | 2. Version 1: Loosen the lock nut wrench (2) and nut (1) shock absorber. At the same time the stock must be held for a wrench flats (3). It should not rotate. |
 | 3. Version 2: Remove the caulking nut with a wrench (1) shock absorber. At the same time the stock must be held for a wrench flats (3). It should not rotate. |
4. Remove the washer (4) and the rubber buffer (5).
5. Lift and establish on supports a back part of the car.  | 6. Remove the 2 bolts (1) of the cover of the spring arm (2) and remove the cover. |
 | 7. Remove the nut (1) of the spring arm and remove the bolt (2) with the washer. |
8. Remove the shock absorber of the spring arm and the holes in the frame. To facilitate the removal of the shock absorber, click on it from above through the hole in the spring arm. Shock removed earlier. |
|
Setting
| 1. Check the shock absorber for smooth running before installation.
2. Check the rubber parts for signs of cracking or damage.
3. Insert the shock absorber so that the digital marking, paint application, pointing backwards.
4. Insert the shock absorber at the spring arm. Install bolt and washer. Screw a new self-stopped nut and tighten its moment of 55nm.
5. Secure the cover of the spring lever and secure it with two screws.
6. Slowly lower the car at the same time enter the shock absorber in the upper hole.
7. Replace the shock absorber rod from interior rubber damper and washer. Secure the new shock absorber rod nut samosoporyaschuyusya 30Nm torque, while holding the cylinder rod from turning. When attaching two nuts: Screw on a new shock absorber rod nut and tighten its moment of 15Nm holding the cylinder rod from turning. Screw a new lock nut and fix it with torque 30Nm holding the bottom nut from turning.
8. Replace the trunk lining, as described in Section Removal and installation of facing in the cargo hold. |
|
|
|
