 printable version
Service speedometer
Refitting | - Disconnect the negative wire from the battery.
- Poddomkratte back of the car and establish it on props.
- Working under the car, disconnect the wiring from the speedometer sensor (position sensor shown in the accompanying illustrations - in the inset shows the location of the connector terminals).
- Set under the hood extension suitable container to collect the oil, which can begin to flow when removing the sensor from the transfer case.
- Inspect drive gear teeth for signs of wear, chips and other damage. If necessary, replace.
|
|
Installation is in the reverse order. Check of serviceability of functioning | - Connect a voltmeter to the terminals of the electrical connector.
- Set the instrument to the measurement mode AC voltage, quickly spin the speedometer drive clockwise and read the voltmeter.
- The result should be about 0.5 V.
- If necessary, replace the sensor.
|
|
|
