REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
			Carbureted engines
			Engines with fuel injection system
			The power supply / exhaust
				Models with one-point electronic fuel injection
				Models with multi-point electronic fuel injection
					Specifications
					Air filter
					An accelerator rope
					The accelerator pedal
					Fuel Injection System
					Fuel system
					Fuel pump
					Fuel Level Sensor
					Fuel tank
					Throttle Body
					Elements of the fuel injection system (engines of 1.6 liters)
					Elements of the fuel injection system (engines of 2.0 liters)
					Intake manifold
			Emission of exhaust gases
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
		Body
		Electrical

printable version

An accelerator rope

Withdrawal

PERFORMANCE ORDER

1. On models with engine capacity of 1.6 liters, remove the air filter housing (see Fig. Subsection 6.3.2.2) to improve access to the end of a rope connected to the throttle body.
2. Unhook the cable from the cam on the throttle body.
	3. Remove the nut cover of a cable to the bracket and remove the cover of a cable from an arm.
4. Release rope across the road paving.
5. In the salon remove the bottom panel of the driver's side.
6. Disconnect the cable from the pedal.
7. Remove the nuts shell to a partition of a motor compartment and remove the cable by pulling the engine compartment.

Setting

PERFORMANCE ORDER

1. Pass the cable through the bulkhead.

2. Pull the cable into the engine compartment and lay in place.

3. Secure the nuts on the cover of a cable bulkhead.

4. Connect the cable to the pedal.

5. Install the bottom panel.

6. Secure the cover of a cable across the road.

7. Attach a cable to the cam on the axis of the throttle.

8. Adjust the cable. On models "Phase II" with a 2.0-liter engine throttle is controlled via an intermediate cam which is mounted on top of the inlet kollektora. Then adjust the setting cam throttle.

Adjusting the throttle cam

PERFORMANCE ORDER

1. Loosen the lock nut and unscrew the stop screw intermediate cam.

2. Hold the cam in the position in which the throttle is fully open, tighten the screw so that it touched the limiting lever. Then, release the cam and turn the screw three full turns clockwise. Hold the screw tighten the lock nut.

3. Move the cam position at which the throttle valve is fully open, and check that the restrictive lever cam screw concerned.

« previos page
Air filter

next page »
The accelerator pedal