printable version
Front gear -snyatie and installation
1. Lift the front of the car and establish on supports. 2. Drain the oil from the gearbox.
| 10.2 Designate position with respect to the propeller shaft flange transfer case |
| 10. 5 Carter and seals the transfer case 1. Tube breather 2. Blind plug 3,8,10. Gland 4. Plug the filling holes 5. Drain plug 6.11. Section crankcase 7. Front Cover 9. The sensor signal of the front axle |
| 11.5a wire connectors to dropbox |
3. Remove the gear unit from the front propeller shaft. 4. Remove the bolts semiaxes to the gearbox, move the axis and secure the wire, preventing sagging at constant velocity joints. 5. Support the gearbox support. 6. Remove the bolts from the gearbox (photo). 7. Remove the bolts of the engine mounts and hang out the engine. 8. Remove the bolts from the gearbox to the frame (see photo). 9. Gently lower the stand and remove the gearbox. 10. Installation is performed in reverse order.
|