 printable version
Hub and knuckle - crushing and installation
1. Lift the front of the car and establish on supports. 2. Remove the wheel. 3. Remove the caliper (Ch. 10) and take aside. 4. Remove the axle shaft. 5. Release the rod end nut and press out the ball tip of the finger knuckle eyes.
6. Remove the knuckle assembly with supports. To do this, lift the lower arm jack. Remove the bolts from the supports to the arms (photo). 7. Remove the fist. If necessary, release nuts puller press out the bearing of a fist. Leave nuts screwed on finger piers. 8. The assembly is performed in reverse order. Adjust the clearance half-axis (see. Above).
| 
