printable version
Semiaxes - removal and installation
1. Lift the car and establish on supports. 2. Remove the wheel. 3. Remove the self-locking device. 4. Remove from the half-axis trunnion lock ring.
| 2.Z Details latching device hub 1. Locknut 2. Lock washer 3.8. Circlip Washer 4. 5. 6. Leash In Washer A Washer 7. 9. The Leash 10. A spring 11. O-ring 12. The housing latching device 13. Details * Grease |
| 2.4 After removing the case, remove the retaining ring, the washer and leash in leash 1. 2. 3. Locking ring Washer A |
| 3.6 Apply a label on the body of the sliding hinge on the gear housing, then loosen the screws |
5. Remove the washer and leash B. 6. Remove the bolts from the half-line to the gear (see photo). 7. Remove the lower bolt shock absorber. 8. Remove the caliper (Ch. 10), take aside and fix. 9. Remove the tie rod. 10. Slightly lower arm hang out jack. Remove the nuts and bolts and remove the ball bearing arms. Carefully remove the axle shaft assembly from the steering knuckle. 11. Knock axle from the fist (photo). 12. Upon detection of defects on parts disassemble the axle shaft (see. Below). 13. Installation is performed in reverse order. Check axial play of the half-line (see photo). If the play exceeds the norm, then pick up the retaining ring thickness (cm. Technical data).
|