REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
			Instructions on operation of tires with the directed road drawing
			Check valves
			Shift of wheels
			Wheels and tires
			Spare wheel
			Changing wheels
			Sekretki-Bolts for wheels
			Anti-skid chains
			Raising the car
		Brakes
		Body
		Electrical equipment and wiring

printable version

Raising the car

A warning

If you need to carry out work under the vehicle, for insurance is necessary to use the stand. Support for only one car jack is not sufficient.

Do not start the engine lifted the car - it's dangerous.

PERFORMANCE ORDER

	1. To lift the car must use a jack mounted under the bearing seat of the car body, which are located about 17 cm from the respective wheel arch.
	2. Place the jack.
A warning If the jack is not installed under the reference location of the body, may damage the vehicle body. In addition, there is a risk of injury. Lapa jack should be tightly cover the vertical edge of the spar to the jack when lifting a vehicle can not slip. At the same time should be to align the position of the jack and the jack to lift the leg until it is firmly not lie down to a vertical edge. When installing the jack on soft ground, the vehicle may fall off the jack. Therefore it is necessary to put the jack on solid ground. If necessary, use a stable and relatively large footprint.
3. For the hanging car must use a lift.
4. To prevent damage to the bottom of the car, be sure to use the appropriate lining of rubberized material.
A warning The car is in any case should not be lifted under the oil pan under the gearbox at the rear or the front axle, or may cause serious damage to components and assemblies.
5. Before entering the lift, make sure that there is sufficient distance between the low-lying points of the car and lift the elements.
	6. At the front of the car lift leg set for vertical reinforced side walls (arrow 1. The middle leg lift must be positioned coaxially with the amplifier underbody (arrow 2).
	7. In the rear leg lift set by the vertical gain spars in the 2 mark on the body for jacking (arrow 1).

« previos page
Anti-skid chains

next page »
Brakes