REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
			Catalyst
			Removing and installing exhaust system
			Alignment exhaust system
			Replacing the middle / rear silencer
			Removal and installation of a silencer
			Removing and installing Lambda probe
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
		Body
		Electrical equipment and wiring

printable version

Removal and installation of a silencer

Location prints on the exhaust pipe

1, 3 - fingerprints for installing a clip;

2 - prints places cutting tailpipe;

4 - clip

Withdrawal

PERFORMANCE ORDER

1. Lift the car and fix on supports.

2. Place disconnecting pipes shown fingerprints on the exhaust pipe. Average mark indicating the place of cutting the exhaust pipe. Ultra prints are for orientation setting a clip.

3. In this spot, cut the pipe exhaust system.

4. Release silencer from rubber mountings and remove it from under the car.

Setting

PERFORMANCE ORDER

1. Install the exhaust system rubber mounting.

2. To connect the pipes of the exhaust system used spare parts - clip. The clamps can not be reused. Install the retaining clip on the place of the exhaust pipes so that the ends of a clip is located near the extreme imprints on the exhaust pipes.

3. Perform the alignment of the exhaust system.

4. Tighten the clamp bracket 40 Nm.

« previos page
Replacing the middle / rear silencer

next page »
Removing and installing Lambda probe