 printable version
The trunk lid
Fasteners lid
1 - the tailgate,
2 - the tailgate trim,
3 - buffer,
4 - a nut, 25 Nm
5 - the hinge lid,
6 - a bolt, 20 Nm
7 - the rubber buffer, | 8 - air support,
9 - lock plate,
10 - a nut 7 Nm
11 - electricity,
12 - casing the joint,
13 - Rubber buffer |
Withdrawal
| PERFORMANCE ORDER | | 1. Remove the tailgate trim. | | 2. Disconnect the electrical connectors in the trunk lid. | | 3. Adhere to the wiring thin long cord and remove the electrically-ku of the trunk lid. Untie the cord and leave it in the trunk lid. In the future, it needs to tighten the cable wiring in the trunk lid. | | 4. Using a marker or pencil, mark the location of the hinge joints on the trunk lid. | | 5. Ask the assistant to support the trunk lid in the open position and remove the air fence lid. | | 6. Remove the mounting hinges on the tailgate and remove the cover from the trunk of the car. |
|
Setting
| PERFORMANCE ORDER | | 1. Set the trunk lid on the car and in accordance with the previously made marks screw to the trunk lid hinges. | | 2. Check and adjust the hinges using the gap between the tailgate and the other elements of the body. Tighten the nuts of hinges for the trunk lid to 20 Nm. | | 3. Fasten harness to the cord and the cord retract the wiring in the trunk lid. Untie the cord and connect the electrical connector to the trunk lid. | | 4. Secure the pneumatic emphasis on the trunk lid. | 5. Water jet, check for leaks trunk:
- A man with a flashlight must be within the boot,
- The second person must direct the jet of water on the trunk. | | 6. In the event of leakage the trunk should be using the hinges and the lock plate slightly lower trunk lid. | | 7. If the boot seal is cracked, replace it. | | 8. To protect the seal put on a thin layer of special funds. | | 9. Refit the lid. | | 10. When driving a car, check whether there are fluctuations in the trunk lid. |
|
|
