 printable version
System of indexes of turns
Tact is flashing and the alarm relay sets. The alarm is connected to a relay without fuse. Direction indicators have a fuse in the fuse box.
Check
If the indicator lamps on the same side is faster than the other, then the "fast" side has failed lamp filament or open circuit.
In all other cases, basically, the reason is a failure of the relay.
Terminals blinker marked:
- Terminal 31 is the weight (less common in the electrical machines);
- Terminal 49 - switch input (plus attached permanently), terminal 49a - relay output;
- On the terminal leads to the control lamp on the instrument panel, in the case of the hitch (optional) may be an additional terminal C2 contrast lamp trailer. | PERFORMANCE ORDER | | 1. If there is no new relay, connect a thin wire terminal 49 and 49a. |
A warning  Without damaging the sensitive relay contacts. The ends of the wire before connecting bend to avoid sharp edges. Set back the faulty relay. Contact him so long, that allow you to do, despite the bridge.
| | 2. Turn the ignition switch. Now, if the indicator is on, the corresponding indicator lamps light up steadily. On-Off turns the pointer, you can set the rhythm, however, without delay, you must install the new relay. | | 3. If, contrary to bridge the direction indicators are off, the faulty switch or turn indicators supply voltage conductor. |
|
|
