REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
			Technical Specifications (SOHC and DOHC)
			Checking the fuel pump
			Checking the pressure created by the fuel pump
			Verification system of injection MFI
			The control lamp fault (MIL)
			DTCs ?�OBD-II?�
			DTCs except ?�OBD-II?�
			Replacement of the fuel filter
			Replacing the overflow limiter (two-way valve)
			Replacing fuel level sensor
			The engine management system MFI
			Fuel injectors
			Throttle knot
			The power supply system with the carburettor
			Check idle speed
			Adjusting the idle speed
			Speed of idling and adjustment of the fuel mixture
			Check and adjustment of the starting device
			Check and adjustment of a free wheeling of a cable of an accelerator
			Fuel tank
			EVAP canister
			Replacement of the fuel filter
			Carburetor
			Cable and accelerator pedal
			Troubleshooting Fuel system with the carburettor
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Cable and accelerator pedal

1 - pin;
2 - the accelerator cable;
3 - an arm;
4 - switch connector accelerator vehicles with automatic transmission;

5 - a bolt, 8-12 N ??? m;
6 - a returnable spring;
7 - the accelerator pedal.

Withdrawal

The accelerator cable

PERFORMANCE ORDER

1. Loosen the adjusting nut accelerator cable.
	2. Disconnect the accelerator cable from the throttle lever.
3. Disconnect the accelerator cable from the lever of the accelerator pedal.
4. Remove the two screws on the accelerator cable sleeve to the partition of a motor compartment and remove it from the vehicle.

The accelerator pedal

PERFORMANCE ORDER

1. Loosen the adjusting nut accelerator cable, disconnect the accelerator cable from the lever of the accelerator pedal, and remove the pedal.
2. Remove the return spring of the accelerator pedal.
	3. Remove the cotter pin from the axis of the accelerator pedal and the accelerator pedal to remove the bracket.

Check

PERFORMANCE ORDER

1. Check the accelerator cable and cable housing damage.

2. Check for smooth movement of the accelerator cable in the shell.

3. Check the accelerator pedal in the absence of bending.

4. Check the condition of the return spring.

5. Check the condition of the tip of the accelerator cable.

Setting

PERFORMANCE ORDER

1. Grease J310a NLGI pivot point of the accelerator pedal.

2. To prevent vapor and exhaust gases in the interior of the vehicle, apply sealant to the threaded bolts of the accelerator pedal arm.

3. Make sure that the accelerator cable has no sharp bends.

4. Check the accelerator cable play.

5. Install all parts and secure with bolts and nuts, having tightened their demanded moment.

« previos page
Carburetor