REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
			Technical Specifications (SOHC and DOHC)
			Checking the fuel pump
			Checking the pressure created by the fuel pump
			Verification system of injection MFI
			The control lamp fault (MIL)
			DTCs ?�OBD-II?�
			DTCs except ?�OBD-II?�
			Replacement of the fuel filter
			Replacing the overflow limiter (two-way valve)
			Replacing fuel level sensor
			The engine management system MFI
			Fuel injectors
			Throttle knot
			The power supply system with the carburettor
			Check idle speed
			Adjusting the idle speed
			Speed of idling and adjustment of the fuel mixture
			Check and adjustment of the starting device
			Check and adjustment of a free wheeling of a cable of an accelerator
			Fuel tank
			EVAP canister
			Replacement of the fuel filter
			Carburetor
			Cable and accelerator pedal
			Troubleshooting Fuel system with the carburettor
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

EVAP canister

1 - canister;
2 - the holder of the canister;
3 - an arm of the fuel filter;

4 - the fuel filter;
5 - a hose of return of fuel;
6 - the fuel return pipe.

Refitting

PERFORMANCE ORDER

1. Pipes shall be secured with clamps and terminals to prevent fuel leakage.

2. After installing the pipes and make sure they are not pinched.

3. Correctly route hoses and pipes and fix them.

4. Install the clamps and clips so that they do not touch any neighboring elements of the vehicle.

Check

PERFORMANCE ORDER

1. Check the hoses and pipes for cracks, bend, deformation, aging and fouling.
2. Check the fuel filter for blockage or damage.
3. Check the canister on the absence of obstructions.
4. Check the overflow limiter (two-way valve) and the fuel control valve cleaning.
	5. Check that the two-way valve, purging it from both sides. If the air is difficult, so the valve is serviceable.
	6. Check control valve clean as follows: - Make sure the coolant temperature is 80-95 ?� C; - Disconnect the hose from the carburettor and cleaning Blow into it. If the valve is closed, then its action is normal. Start the engine and increase the engine speed to 1500-2000 ^min -1 and Blow hose. If the valve is closed, check the condition of the vacuum hose or thermo job.

« previos page
Fuel tank