add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)
general info. full specifications. diagnostics. hints. tips. tricks
 Hyundai Elantra
Home
 
Hyundai
Elantra
Gasoline engines 1.6, 1.8 and 2.0 liters
The diesel engine of 2.0 liters
Greasing system
Cooling
Fuel system
Control systems and emission control
Ignition system
The system of preliminary heating of the diesel engine
Coupling
Manual transmission
Automatic Transmission
Drive shafts, front and rear axles
Suspension
Steering
Brakes
Technical data
Check the brake servo
Check unilateral vacuum valve
Bleeding the hydraulic system of a drive of brakes
Adjust the parking brake stroke
Brake pedal
Vacuum brake booster
The main brake cylinder
Replacing the front brake pads
Caliper front brake
Rear disc brakes
Rear drum brakes
Replacing the working brake cylinder
Pressure regulator
Brake tubes and hoses
Parking brake
Anti-lock brakes (ABS)
Hydraulic block HECU
Wheel speed sensor
Bleeding the hydraulic system of a drive of brakes with scanner use
Troubleshooting
Body
The air conditioning system
Electrical equipment
Electrical diagrams
 


Hit Counter by Digits


print page printable version

Vacuum brake booster



Withdrawal

PERFORMANCE ORDER

  1. Disconnect the brake pipes from the master cylinder.
  1. Remove the brake master cylinder. Torque: 8.12 N ??? m.
  1. Disconnect the vacuum hose from the vacuum brake booster.
  2. In the car, remove the spring pin and remove the pin with a head and a hole for the pin.
  3. Remove the four nuts of the vacuum brake booster.
  1. Remove the vacuum brake booster.

Setting

PERFORMANCE ORDER

  1. When installing the brake servo, remove the two sides of the amplifier transport packaging.
  2. Install a vacuum brake booster with a new seal on the bulkhead and secure with four nuts. Torque: 13-16 N ??? m.
  3. Apply a layer of grease on the mounting hole in the brake pedal.
  1. Connect traction brake pedal and set the pin with a head and an aperture under the pin and secure it with a new spring cotter pin.
  1. Install the brake master cylinder to the brake servo and secure the nuts. Connect the brake pipes and tighten the nuts connecting tubes.
  2. From the engine compartment, connect the vacuum hose to the brake servo.
  3. Fill popolnitelny tank of brake system with brake fluid. Remove air from the hydraulic circuit brake system.
  4. Check the brake fluid leaks.
  1. Check and, if necessary, adjust the height of installation of a pedal and brake pedal free wheeling.
  1. After installation, lubricate the contact point of the brake pedal and pull.




« previos page
Brake pedal		 next page »
The main brake cylinder

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.