add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Matrix (2002 and 2006 model year)
general info. full specifications. diagnostics. hints. tips. tricks
 Hyundai Matrix
Home
 
Hyundai
Matrix
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Overview
Checking and adjusting the brake pedal
Check the operation of the brake servo without tester
Removal of air from hydraulic brakes
Check and adjust handbrake lever stroke
Removing and installing brake servo
Check the brake system of highways
Removing and installing brake pedal
Removal, check and installation of the front brake pads
Dismantling, check and assemblage of the brake caliper
Disassembly, inspection, assembly and installation of the main brake cylinder
Pressure regulator rear brakes
Removal, check and installation of the rear drum brakes
Replacing the working brake cylinder
Removal, check and installation of the parking brake
Anti-lock brakes (ABS)
Removal and installation of the electronic ABS control unit
Removal and check wheel speed sensor (ABS)
Tables
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Replacing the working brake cylinder



Remove the brake pads.
Disconnect the brake pipe from the cylinder.

Bolts wheel cylinder
Fig. 6.51. Bolts wheel cylinder


Remove the two screws and remove the wheel brake cylinder (Fig. 6.51).
Remove the cylinder sleeve.
Remove the cover of the piston and the piston.

Return spring
Fig. 6.52. Return spring


Remove the return spring (Fig. 6.52).

The components of the wheel brake cylinder
Fig. 6.53. The components of the wheel brake cylinder


Before assembling the wheel brake cylinder, check the items listed below (Fig. 6.53).
The cylinder and piston - for wear and rust.
Cylinder - for cracks and other damage.
Condition of the contact surface of the piston and brake pad.
Status of the return spring.
Assembly and installation of the brake wheel cylinder in reverse order.

NOTE
Before assembly, wash the parts with isopropyl alcohol.
Before installation, lubricate the parts with clean brake fluid.
Lids and seals the piston is not re-established.

ATTENTION
Be careful not to lose the steel ball of the drain fitting.




« previos page
Removal, check and installation of the rear drum brakes		 next page »
Removal, check and installation of the parking brake

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.