add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
general information
Troubleshooting - General Information
Removing and installing selector lever
Check and adjustment of a cable switch
Description, replacement and adjustment of the throttle cable mode kickdown (TV-cable)
Check of adjustment and replacement of the gauge-switch of the permission of start
Adjustment of a cable parking bollard
Check and replacement of support of transmission
Replacing the gland
Description of the construction, removal and installation of lines and transmission cooling hoses
Removal and installation of additional cooling
Removing and installing automatic transmission
Replacing the transmission control module (TCM) (only for the AW-4 and 42RE)
Diagnosis of electronically controlled automatic transmission
Transfer Case
Clutch and transmission line
Brakes
Suspension and steering
Body
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Replacing the transmission control module (TCM) (only for the AW-4 and 42RE)



Transmissions 42RN 46RN and are not equipped with a separate control unit - shift control to them is carried out by the control module (PCM).

Transmission control module located under the dashboard on the driver's side of the car (to the left of the steering column).

Transmission control module (AW-4).

Transmission control module (42RE).

PERFORMANCE ORDER

  1. Disconnect the electrical connector.
  2. Give bolts and / or nuts of the module.
  3. Remove the module from the panel of the fairing.
  4. Install in reverse order.




« previos page
Removing and installing automatic transmission
next page »
Diagnosis of electronically controlled automatic transmission

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.