 printable version
Principle of operation and check of serviceability of electric rearview form
Side mirror Power change the position of glass mirrors used in his work two motors; one for the vertical adjustment and one - horizontal. The switch is equipped with a selector control device that provides power to the left or right side mirror. Turning the ignition key to the parking brake (ACC) position, lower the window glass popereklyuchayte mirror control switch position, guide him through all positions. (left-right and up-down) to both mirrors. | - Listen carefully to the sounds made by the drive motors of the mirrors.
- If the motor hums, but the mirror does not move, perhaps there is a malfunction of the drive in the mirror. To determine the cause of failure, remove the mirror and disassemble it.
- If the mirrors do not work and their drive motors do not emit any sound, check the fuse 15 A in the mounting block to the right under the dashboard (Section Fuses - general information).
- If the fuse is OK, remove the trim panel switches (head body) to provide access to the rear of the mirror control switch position without disconnecting the wires from it. Turn the ignition (key in position ON) and check the voltage on the switch. On one of the terminal voltage must be present. If the voltage on the switch is not fixed, check the wiring between the switch and fuse block assembly for an open or short circuit.
- If the voltage occurs, disconnect switch. Check the conductivity of the switch in all of its operating positions. In case of violation of conductivity replace the switch.
- Reconnect the switch. Find the wire from the switch to ground. Leaving the switch is connected, connect terminals equipped with a wire between the wire and ground. If you now drive the mirror operate normally, restore the grounding.
- If the drive still does not work, remove the mirror and check on his power wires. Checks are made when the ignition (key in position ON) or the correct position of the selector switch. Spend a mirror control switch through the operating position. In each of them (except for the neutral (OFF)) voltage must be present on one of the wires from the switch to the mirror.
 | - Check the power switch on the socket connection with the motor drive mirror.
|
- If the voltage is not in any position of the switch, check the wiring between the mirror and the presence of open and shorts.
- If the voltage is the case, remove the mirror and make sure it is connected directly to the battery. If the refusal to take place now, replace the mirror.
|
|
Mirrors with automatic switching of day / night modes | - To reduce the intensity of the reflection in the mirror automatic switch day / night mode provides the ability to adjust the light-reflecting mirror depending on external conditions. This function is performed by using two photocells, one of which faces forward, the other is turned back. Elements manage darken or lighten a thin elktrohimicheski active layer embedded in the glass mirror.
- When the ignition switch of the non-equipped models in the upper hatch upper (High) or lower (Low) position on models equipped with the hatch slide the power switch to the ON (ON).
- Cover the solar cell facing forward, highlight rotated back and make sure that the blackout was a mirror surface, and then place the transmission in reverse gear position and make sure the surface of the mirror brightened. If not disunite an electric socket. With the ignition on slot 1 must be present battery voltage, the conductivity between the socket 2 and the ground should be absent, with 3 must be installed on the conductivity at a reverse gear train.
- In case of failure of any of the above conditions, replace the mirror (head body).
|
|
|
