printable version

Recovery Options Engine

At independent performance of procedures of major repairs of the engine mechanic-fan will face the possibility of implementing it in several different ways. The first of the criteria by which determined the need for replacement of an engine block, connecting rod and piston assembly and the crankshaft is the state of the cylinder. Among other factors include material costs, access to machinery equipment, the definition of the list of necessary spare parts and the possibility of their acquisition. Moreover, the necessary condition is the presence of free time and expertise of independent performance of mechanical work.

The cost of the following alternatives to engine overhaul may vary depending on the quality of purchased parts, a broad spectrum of necessary machining and quality required to perform the procedures of special tools and equipment. Many repair shops in addition to the repair of the individual components are taken for the implementation of the complete assembly of the engine (with the installation of a full or abbreviated dialing). Consult in nearby garages on the spectrum of their work and their prices.

The main engine of the recovery options are:

Replacing individual components - If the preliminary analysis of the engine revealed that the engine block and most of the engine components are fit for further use condition, the acquisition and installation of a single defective component can be the most reasonable and economical way out. In this condition of the block, crankshaft and connecting rod and piston assembly must be checked very carefully. Even with the slight degree of wear in the block should be made mandatory honing cylinders.

Setting Abbreviated Dialing unit - Abridged set consists of the complete engine with the crankshaft and connecting rod and piston assembly. This should be a new set bearings and exhibited all gaps. In such a block after a minor (if required) machining set the old camshaft, valve train components, the head (s) of cylinders and hinged units.

Setting of the full set of unit - full set includes a reduced set, plus the oil pump, an oil pan, head (s) of the cylinder cover (s) of the head, camshaft and valve train components, electrical sprocket with chain or gear and timing cover (chains). All components are mounted with new bearings, seals and gaskets, and all you need to do is install the intake manifold, exhaust manifold (s) and ancillaries.

Carefully weigh the pros and cons when you select the recovery engine, consult your local dealer or service center shop office and only then proceed to purchase the necessary spare parts.