REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Clarus (1995 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Clarus
		Maintenance
		Engines FE DOHC and DOHC T8
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		ACP G4A-EL
		AKP 50-40 LE
		Axes and power shafts
		Steering
			Technical data
			Check of a free wheeling of a steering wheel
			Check of effort steering
			Belt drive power steering pump
			Checking the fluid pressure in the hydraulic system
			Replacement of a protective cover of steering draft
			The steering shaft
			Steering transfer
			Power steering pump (FE DOHC)
			Disassembly and assembly of power steering pump (FE DOHC)
			Troubleshooting
		Wheels and tires
		Suspension
		Body
		The air conditioning system
		Electrical equipment
		Brakes
		Electric schemes

Replacement of a protective cover of steering draft

Protective Case Tie Rod End

1 - pin;
2 - a nut;
3 - tie rod end;
4 - a protective cover rod end;

5 - lock nut;
6 - a collar;
7 - wire.

Withdrawal

PERFORMANCE ORDER

1. Lift the front of the car and fix on supports. Remove the wheel.
2. Remove the plastic shield protecting the wheel arches.
3. Turn the wheel to the left until it stops.
4. Remove the cotter pin and loosen the nut ball joint tie rod to the steering knuckle. To loosen the nut until it reaches the end of the finger.
	5. Stripper OK130 283 021 squeeze the finger of the spherical rod end from the knuckle.
A warning To avoid damaging the screw thread on the thread of the stud nut temporary. Do not tighten the nut hard to avoid damaging the threads.
	6. Mark the position of the tie rod, loosen the lock nut and unscrew the tie rod from the steering rod.
7. Attach the tie rod in a vise.
	8. Push the chisel into the cover, holding it at an angle as shown in the figure.
9. Slowly, being careful chisel and moving around the joint, bring down a protective cover.
A warning Do not damage the place fit the dust cover to the steering rod.
10. Cut the wire and release the clamp of a protective cover of steering transfer.
11. Remove the lock nut from steering draft.
12. Moving on steering draft, remove the protective cover of steering transfer.
13. Remove the clamps with a protective cover.

Setting

PERFORMANCE ORDER

1. Apply a small amount of grease inside the protective cover of tie rod.
	2. The press and the mandrel install a protective cover on the tie rod end.
3. Fill in the new protective cover of steering transmission lubricant.
4. Apply a thin layer of grease to the mating surfaces of a protective cover.
5. Pulling on steering draft, install a protective cover of steering transfer. Fix the big party cover wire by wrapping it in two turns and tighten the ends of the wire 4-4,5 times.
6. Secure the case with the smaller side clamp.
7. Screw the lock nut of steering draft and combine the labels put before a reversing of a nut.
8. Screw a tip of steering draft and combine the labels put before a reversing of a tip.
9. Tighten the tie rod lock nut.
10. Install the finger of the spherical rod end to the knuckle.
11. Screw the nut and finger tighten its demanded moment.
12. Install the cotter pin.
13. Install the wheel.
14. Lower the car.
15. After installation, check wheel alignment.