REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Clarus (1995 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Clarus
		Maintenance
		Engines FE DOHC and DOHC T8
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		ACP G4A-EL
		AKP 50-40 LE
		Axes and power shafts
		Steering
			Technical data
			Check of a free wheeling of a steering wheel
			Check of effort steering
			Belt drive power steering pump
			Checking the fluid pressure in the hydraulic system
			Replacement of a protective cover of steering draft
			The steering shaft
			Steering transfer
			Power steering pump (FE DOHC)
			Disassembly and assembly of power steering pump (FE DOHC)
			Troubleshooting
		Wheels and tires
		Suspension
		Body
		The air conditioning system
		Electrical equipment
		Brakes
		Electric schemes

Steering transfer

1 - pin;
2 - a nut;
3 - Tie rod and ball joint;

4 - motor mount;
5 - a returnable hose;
6 - steering gear and drive.

Removing the steering gear should be carried out on the right side of the car.

PERFORMANCE ORDER

1. Loosen the wheel nuts.
2. Lift the car and fix it on support.
3. Remove the wheel.
4. Remove the cotter pin and loosen the nut ball joint tie rod to the steering knuckle. To loosen the nut until it reaches the end of the finger.
	5. Stripper OK130 283 021 squeeze the finger of the spherical rod end from the knuckle.
A warning To avoid damaging the screw thread on the thread of the stud nut temporary. Do not tighten the nut hard to avoid damaging the threads.
6. Remove the bolt connecting the universal joint shaft and pinion steering gear.
7. Drain the hydraulic drive power steering.
8. Remove the pressure and return hoses from the steering gear housing.
9. Remove the crankcase bolts steering transfer.
10. Move the steering gear and get it on the right side of the car.
A warning When removing the steering gear, be careful not to damage the protective covers.

Setting

PERFORMANCE ORDER

1. Installation is spent to sequences, return to removal.
	2. screw nut fastening of steering transfer in the order shown in the figure. Torque: 31-46 N ??? m
	3. Connect the intermediate shaft and the gear shaft and fix a bolt, having tightened its demanded moment. Torque: 18-27 N ??? m
4. After installation, bleed the steering system and, if necessary, adjust the convergence.