 printable version
Seats - general information, condition check, removal and installation of components
general information The design and details of the installation of seats The front seats The front seats are set apart and are regulated individually. Sled each seat are attached to the guide frame attached to the vehicle floor by means of three screws and one nut each. The drive lever is released, the slide locking mechanisms derived under the front edge of the cushion and allow the seat adjustment in the longitudinal direction. Another one adjustment lever displayed on the outer edges of the seat assembly, - pulling lever handle up leads to releasing the lock of the back and allows you to adjust the slope of the latter, by its forced push down (when it is released back automatically placed in the full forward position under the influence of special spring). To the right on the back of the driver's seat adjustment lever is placed as the configuration of lumbar support. Backseat Rear seat with a solid cushion can be equipped as a whole, and divided into two individual sections of the backrest. The backs are equipped with integrated headrests. The pillow has a buttonhole attachment to the floor, allowing the assembly to swing forward with the transfer of the seat to the upright position - back (s) must first drop forward. Mounting assembly and the floor is performed by means of two bolts, two nuts and one rear lock. Fixing the back (s) in an upright position is provided by two built in in the walls of luggage hooks. Check | - Check out the smooth progress of the adjustment lever of the front seats, evaluate the degree of wear of components locking mechanisms. Replace defective parts.
- Make sure of the reliability of a tightening of all the threaded fasteners - if necessary, tighten it with demanded effort.
- Lubricate moving parts slide, drive levers and locking mechanisms.
|
|
Removal and installation of components Front seatback | - Remove the handle lever is released, the locking mechanism back.
 | - Remove the decorative cap, turn out fixing bolts and remove the side cover of the base assembly seats.
|
 | - On the driver's seat, remove the retaining screw and remove the adjusting lever configuration lumbar support back.
|
 | - Remove the ring clamps attaching the seatback cover.
|
 | - Remove the hinge bolt back.
|
- In order to provide access to fasteners knuckle back up DELAY upholstery latter.
 | - Turn out fixing bolts and remove the knuckle and separate the back of the cushion.
|
- Installation is in the reverse order, - check compliance with the requirements of the Specifications Body to the efforts of a tightening of threaded fasteners.
|
|
Assembling the rear seat | - Stretching located outside of the head restraint push-button locks, lower back forward (and) seats.
- Remove the two mounting bolts and nuts give two seat cushions on the floor.
- Remove the rear seat assembly and remove it from the vehicle.
- If necessary, remove the hinge screws and separate the back (s) of the cushion.
- Installation is in the reverse order, - check compliance with the requirements of the Specifications Body to the efforts of a tightening of threaded fasteners.
|
|
|
