 printable version
Outdoor equipment and body parts
Removal, installation and adjustment of components of the device cleaning and washing of windshield Scheme of the windshield cleaning Replacement brush | - Pull the lever on the brush to be replaced windscreen.
 | - Press the locking tab in the lock and remove the brush from the last hook on the end of the arm.
|
- When planting brush lever track reliability latch it closed.
|
|
Withdrawal Levers of screen wipers with brushes | - Make sure that the windscreen wipers are in the "parking" position - if necessary, switch on the ignition, start again and stop the wipers.
 | - Remove the cap, release the retaining nut and remove the arm from the spindle drive traction.
|
|
|
The electric motor drives the wiper |  | - Open the hood and remove the four bolts securing the wiper motor drive.
|
- Disconnect the wiring.
 | - Separate the motor assembly from the fairing panel and prying with a screwdriver, separated from it by a drive rod wiper.
|
- Remove the electric motor.
|
|
Traction Drive Wiper | - Remove the six mounting screws, release the two catches and remove the grille (see. Section Removal and installation of the cowl grille).
- Give fixing bolt and a nut and, acting on the left side of the car, remove the drive rod assembly wiper cowl panel.
- Manually check rotation articulations freedom of assembly, if necessary, add lubricant.
|
|
The tank and the pump supplying washer fluid | - Disconnect the negative wire from the battery.
- Disconnect the electrical wiring of the pump and fluid hose.
 | - Turn out fixing bolts and remove a tank mounted with a pump from the engine compartment.
|
|
|
Setting |  | - Installation is in the reverse order. Make sure the correct state when connected to an electric motor drive him thrust - brush after installation must be in the "parking" polozhenii.Ves fixture tighten with demanded effort.
|
|
|
Adjusting washer fluid nozzles feed |  | - Adjustment is made by turning the jet nozzle introduced his work bore needle - jet should fall into the right place on the glass.
|
 | To avoid breaking of a needle in a jet, you should first "release" in the heat of the flame lighters. |
|
|
|
